How to use ubiquiti er-12 as load balancer with bezeq fiber

פורום רשתות, IT ומחשוב כללי - רשתות, ראוטרים, מחשבים ניידים, אביזרים וכו'.
niv314 (פותח השרשור)
חבר שרק התחיל
חבר שרק התחיל
הודעות: 13
הצטרף: אוקטובר 2011
נתן תודות: 0
קיבל תודות: 0

How to use ubiquiti er-12 as load balancer with bezeq fiber

נושא שלא נקרא #1 

  • upgrade to latest firmware version and last boot loader version
I connected the SFP from Bezeq to port eth11
and a ethernet cable from Hot router to eth0

In the Gui run the wizard for load balancer. and define the primary as eth11. the SFP in my case, define pppoe
secondry is eth0 . Hot in my case
save and reboot

open the CLI in the web interface and login using the user you created in the wizard
run these commands to define the pppoe correctly. as the wizard failed to do so:

קוד: בחירת הכל

# configure 
# set interfaces ethernet eth11 pppoe 1 user-id user@014 
# set interfaces ethenrnet eth11 pppoe 1 password PASSWORD
# commit
# show interfaces ethernet eth11 pppoe
# save
# exit
now you can check the status:

קוד: בחירת הכל

# show load-balance status

שלח תגובה

חזור אל “רשתות, אינטרנט ו- Fiber”